Author: Leah Rowe <email@example.com>
Date: Wed, 9 May 2018 23:56:19 +0000
Merge branch 'swifix' of swiftgeek/libreboot into master
3 files changed, 6 insertions(+), 6 deletions(-)
diff --git a/docs/gnulinux/encrypted_parabola.md b/docs/gnulinux/encrypted_parabola.md
@@ -284,7 +284,7 @@ directory to the one you created in the previous steps, so that you can modify f
and install software onto it, as if it were the host operating system.
To `chroot` into your installation, follow the instructions [on the
-Prabola beginner's guide](https://wiki.parabola.nu/Beginners%27_guide#Chroot_and_configure_the_base_system).
+Parabola beginner's guide](https://wiki.parabola.nu/Beginners%27_guide#Chroot_and_configure_the_base_system).
### Setting up the Locale
Locale refers to the language that your operating system will use, as well as some
diff --git a/docs/install/bbb_setup.md b/docs/install/bbb_setup.md
@@ -236,7 +236,7 @@ Output:
Verify that the spidev device now exists:
- # ls -al /dev/spid
+ # ls -al /dev/spid*
diff --git a/docs/install/c201.md b/docs/install/c201.md
@@ -155,10 +155,10 @@ to be opened.
The SPI flash is located next to the write protect screw. Its layout is
indicated in the picture below. Note that it is not necessary to connect
-`WP#` since removing the screw already connects it to ground. Before
-writing to the chip externally, the battery connector has to be
-detached. It is located under the heat spreader, that has to be
-unscrewed from the rest of the case. The battery connector is located on
+`WP#` since after removing the screw it is pulled up weakly to 3v3. Before
+writing to the chip externally, the battery has to be unplugged.
+Battery connector is located under the heat spreader, that has to be
+unscrewed from the rest of the case. It is located on
the right and has colorful cables, as shown on the picture below.